aquaonline.blogg.se

Open your routers nat type for mw2 on mac
Open your routers nat type for mw2 on mac






open your routers nat type for mw2 on mac

Make sure that all the extra switches/routers have DHCP Disabled.

#OPEN YOUR ROUTERS NAT TYPE FOR MW2 ON MAC FREE#

If it is below 75% (Align the antenna to face each other better)ĩ) Once a link is established then feel free to connect switches and routers to the MAIN and SECONDARY routers. With DHCP disabled, this will force it to pull IPs from the primary routerĦ) Configure the Routers to use WDS (this is in the wireless tab)ħ) Configure the routers for Wireless G onlyĨ) Verify the are connected by going to the STATUS>Wireless page in the routers GUI, at the bottom you should see the signal strength. the router on the other side of the wireless link, lets call it secondary, should have the ip address 192.168.6.2 (TWO). Your Main router should be set to distribute DHCP and have the 192.168.6.1 IE instead of 192.168.1.1 use instead (like I did) .1 The sides are determined by facing the front of the router.Ĥ) Turn up the antenna power slightly (recommended is 73, I am using 100 in well ventilated area)ĥ) Set the IP address on the router/gateway to something easily recognizable as unique in order to verify your network is working later. The side on the router is female, so your converter to hook up an “N-type” cable needs to be RP-TNC (MALE).ģ) Configure the router to use 1 antenna. Most large external antenna use “N-type” connectors. No obstructionsĢ) Cable the Grid Antenna to your router. (this will work without the grid antennas if the distance is short)ġ) Set up Directional Grid Antennas to face each other with good LOS (Line of Sight). Set up Grid Antennas with clear line of sight to each other

open your routers nat type for mw2 on mac

Simple Overview- Set up WRT routers at each spot you will use a wireless link. Each side can play system link xbox 360 games with no issue, but not with the people on the other side of the road. Each lan has multiple switches and routers plugged into each other. They are split by a Road that can not be traversed with cable for cable-hazard reasons and because the distance is over 130 meters. Trying to connect 2 separate lans together. Only 1 span (point to point) link needing to be covered via wireless.Ģx Linksys WRT54GL flashed with DD-WRT v24 sp2 (10/10/09)Ģx RP-TNC Male to N (Male/Female) adapters Connect 16 xbox 360 together for system link play over a large physical area (road bisecting the area).








Open your routers nat type for mw2 on mac